News
Current Position： Home
> News
What is the cause of overheating of the gas mold temperature controller?
announcer：
The gas mold temperature controller has overheated. The first thing to say is that there is a problem with its thermostat. In fact, the gas mold temperature machine actually outputs its signal through the thermostat. Next, we actually want to control the work of its electric heating tube. When a series of problems occur in the thermostat, when its temperature reaches a series of set values, the thermostat will not send a signal.
At this time, as far as the gas mold temperature machine is concerned, we actually need to pay attention to the fact that the temperature of the electric heating tube will continue to rise after stopping heating. In this regard, we actually will It was found that a series of over-temperature phenomena appeared.
The reason why the gas mold temperature controller will overheat is actually because of the solenoid valve that controls the cooling water, or other control valves have burned out. In this regard, in fact, it will always be in In a certain closed state, when cooling is required, the cooling water is actually not allowed to enter. In this respect, in fact, it will directly cause the phenomenon that its temperature is too high.
Regarding the overheating phenomenon of the gas mold temperature controller, there is another possibility that the electrical part is not set in place. When we have a problem with heating, we can actually change a heating tube. As far as the last case is concerned, in fact, the temperature control equipment directly belongs to the heat release process. The power of the mold temperature cooler is relatively small, and the temperature of the heat transfer medium is actually relatively high, and it cannot be reduced. The phenomenon.
To a certain extent, the gas mold temperature controller actually means to save manpower and improve its quality. Immediately, we also need to pay attention to the business strategy that should reduce costs. In fact, the gas mold temperature controller is urgent. In fact, the preheating time of the mold can be reduced, and the surface quality of the finished product can be improved and it can be fully automated.